Transmission setting
SDA_FORCE_OUT | 1: direct output, 0: open drain output. |
SCL_FORCE_OUT | 1: direct output, 0: open drain output. |
SAMPLE_SCL_LEVEL | This register is used to select the sample mode. 1: sample SDA data on the SCL low level. 0: sample SDA data on the SCL high level. |
RX_FULL_ACK_LEVEL | This register is used to configure the ACK value that need to sent by master when the rx_fifo_cnt has reached the threshold. |
TRANS_START | Set this bit to start sending the data in txfifo. |
TX_LSB_FIRST | This bit is used to control the sending mode for data needing to be sent. 1: send data from the least significant bit, 0: send data from the most significant bit. |
RX_LSB_FIRST | This bit is used to control the storage mode for received data. 1: receive data from the least significant bit, 0: receive data from the most significant bit. |
CLK_EN | Reserved |
ARBITRATION_EN | This is the enable bit for arbitration_lost. |
FSM_RST | This register is used to reset the scl FMS. |
CONF_UPGATE | synchronization bit |